BURNSIDE CARBINE SERIAL NUMBERS SERIAL NUMBERS

Take it apart, thoroughly clean and inspect it before you fire it, or at least If you choose to fire an antique weapon versus displaying it, you will want to Significant for an unfired piece, a weapon never gets in better condition as it Originality and condition of a historic piece, sometimes this premium is very Would consider any cleaning or use of a historic piece to be a compromise. There is risk of blockage, stressed metal, improper loading, and other problems that might not be imagined. Years, and the better ones have probably not been fired since the Civil War Of these weapons have not been fired in at least 100 It should be carefully inspected, cleaned, serviced, and tested before firing. With any antique, special care needs to be exercised, you do not want to simply take the thing off Safety is also a concern if youДrive an antique car on the road. Is always a concern with antique weapons. They are old, they are antique, and some are compromised and altered well beyond their original design. Of antique weapons: Pre 1898 weapons are not regulated because the Handled or used maliciously, so please be careful with them. One caution though, the weapons can be dangerous if not properly Therefore none of the rest of the law applies to antique weapons made before This means that pre 1898 weapons are excluded from the law by definition, (A) any firearm (including any firearm with a matchlock, flintlock, percussionД¬ap, or similar type of ignition system) manufactured in or before 1898 or. Such term does not include an antique firearm. (C) any firearm muffler or firearm silencer or (B) the frame or receiver of any such weapon Readily be converted to expel a projectile by the action of an explosive (A) any weapon (including a starter gun) which will or is designed to or may The following relevant excerpt is taken from the law: The complete text of the law can be found in the Cornell online law library: That they can be owned, or shipped through the mail, no permitting or licensing This exempts antique firearms from regulation, which means Research Center: Weapon2455-Breechloader-Spencer-Carbine-Model-1865. Most were fitted with the Stabler cutoff, which effectively converted the repeater back to single shot, this slowed the shooting but reduced jams. In addition the smooth thumbstall on the magazine was replaced with a ridged thumbstall, and the hammer was redesinged with a bevel to narrow the striking surface. The Model 1865 featured a shorter barrel, 20 inches, versus 22 inches. Cartouches on the left side on the butt are typically weak, additional inspector marks on the receiver, and barrel. Additional vertical stamping MODEL / 1865. Mark on top of frame: SPENCER REPEATING RIFLE / PAT'D MA/ MANUF'D AT PROV.R.I.

Spencer Model 1865 was manufactured by Burnside Rifle company, Providence Rhode Island. Burnside introduced 3 groove rifling, otherwise most of the Spencer design details were followed.

The straight cartridge used for the Model 1860 carbine was replaced with a new tapered cartrige, referred to as 56 /52 or 56 /50, the actual bullet was either.

BURNSIDE CARBINE SERIAL NUMBERS SERIAL NUMBERS

Approximately 34,000 were produced, serial numbers ran from 1 to 34000. Spencer Model 1865 carbine was manufactured by Burnside Rifle company, Providence Rhode Island. W1438 # Breechloader, Spencer seven shot rimfire carbine, Model 1865, 56/52 cartridge, cavalry model fitted with saddle riding bar. USA (changed hands 70 times in the Civil War!)

Ridgeway Reference Library, Civil War plates and buckles

Burnside carbine serial numbers